How to remote control your Rock64 with VNC secured by a SSH tunnel.

In need to remote control your Rock64’s desktop? Here is a small step by step guide based on a Rock64 running on Armbian Debian 5.65.

How to install VNC and connect to it through a secure SSH tunnel?

Before continuing be sure to be a sudoer, that means that the user you’re using has the sudo privilege.

First of all we’ll update the packages, install all the dependencies and install the VNC server:

Once the VNC server has been installed, we need to set up the password for the future connection. Notice that we are not using sudo this time, because we want to connect with the current user:

Setting up the password and launching the VNC server

Choose a password that you’ll use to connect to your Rock64 through the VNC client. You can answer no to the view-only password question.

First we stop the running VNC instance with:

Then we create a configuration file to configure TigerVNC to use Xfce. Copy/paste the following lines

The > will be added automatically

Now we give the right permissions to this file:

We can predifine the geometry and dpi that’ll be used with command. I suggest you to use copy and paste:

Starting the VNC server automatically. We are going to create a service that the system will start at boot time, please use the following commands, be sure to add your user name and whatch out for the apostrophes as Medium replace the chars with another one (have a look at the screenshot):

The service has been created

Now we have to set the correct owner for the file and move it in the right folder:

We notify systemd that a new service is available by running this command:

And we enable the service, that means the Rock64 will start this service at boot time:

We start the VNC service by using this command:

And verify that the service is successfully started:

The service is running just fine

You have to run the following command on any macOS or Linux that wants to connect to the Rock64 through the VNC by creating an SSH tunnel:

Don’t forget to put in the previous command your username and the Rock64’s IP address.
You’ll be prompted for the password you’ve just set previously with the command vncserver.

Now to connect, just download any VNC viewer (TigerVNC, TightVNC, RealVNC, VNC Viewer) and try to reach for:

You’ll need to use PuTTY SSH client in order to create the SSH Tunneling:

On the left pane, go to Connection, choose SSH and click on Tunnels. The port you have to set is 5901 in the source port field and set your Rock64’s ip address, followed by :5901, in the Destination field:

You can save these settings by going back to Session.

Open this session and now connect usingany VNC viewer (TigerVNC, TightVNC, RealVNC, VNC Viewer) trying to reach for:

Graphically check the health of your Rock64 with S-Tui

S-Tui is a graphical interface to let you monitor your Rock64 through SSH. It is pretty straightforward to install, just enter these commands:

Say yes to all questions and carry on with these commands that will install s-tui:

Now it has been installed, to launch it:

Too bad the Rock64 has no Power sensor

Final word

Now it’d be easy to manage your Rock64 from your local computer using a graphical interface.

To configure your VNC server to start a display for more than one user, create the initial configuration and set up the password using the vncserver command. Don’t forget to create a new service file using a different port.

IT Guru • Defender against the Digital Dark Arts🛡 • Blockchain Advocate 🔑️. https://xn--l9hygo898lbsb.y.at